This patch adds information about a vlan filtering bridge to the
operational datastore.
The information included is vlans, pvid and stp-state. These changes
reflects what can be configured though confd.
NOTE: pvid is still missing for bridge interfaces. Discussions on how
to best add this is ongoing. It's currently not configurable due to an
existing self check in the infix-if-bridge yang model.
Signed-off-by: Richard Alpe <richard@bit42.se>
This can now a days be inferred and isn't needed. Also, the interface
type in virtual testing is now etherlike not ethernet.
Signed-off-by: Richard Alpe <richard@bit42.se>
This resolves the regression where configured etherlike interface mac
addresses where not deleted from the system.
Signed-off-by: Richard Alpe <richard@bit42.se>
* Remove bogus ethernet statistics for br0
* Change parentbus for e0 and e1 to make them ethernet devices (not
virtio -> etherlike).
Signed-off-by: Richard Alpe <richard@bit42.se>
Instead of "ethernet". Prior to this patch virtio interfaces where
identified as "ethernet", which resulted in /run/net trying to enable
autoneg on them. Which isn't supported and resulted in an ABANDONED
"default config".
Signed-off-by: Richard Alpe <richard@bit42.se>
Needed for devices that share a lot of properties with an ethernet
device but doesn't support "ethtool" and such. An example is TAP
interfaces.
Signed-off-by: Richard Alpe <richard@bit42.se>
Rely on the interface diff to figure out if any autoneg related config
has changed; if so, generate the resulting configuration based on the
current interface config.
- Remove loopback check, the model only allows ethernet config on
interfaces of type "ethernet".
- Split up the input validation of speed/duplex to give the user an
error message with as much specificity as possible.
- Validate that the configured speed/duplex is supported.
- Move the generated script to execute earlier to avoid unnecessary
link flapping.
- Use negative POSIX error codes, these are (or at least should be)
mapped to sysrepo errors in netdag_gen_iface.
Add the ability to configure interface speed, duplex and autoneg.
Initially this was pared with YANG model deviations that restricted
explicit interface speed and duplex when autoneg was enabled. But due
to conflicting default states in YANG, this code was dropped.
Signed-off-by: Richard Alpe <richard@bit42.se>
The Infix scan token we have is only valid for KernelKit, so for any
downstream forks we must not attempt to run this workflow.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
