By default, assume that any LED with the function "tp", "sfp" or
"port" is attached to either an Ethernet PHY or MAC, with support for
offloading the "netdev" trigger.
Use green LEDs to indicate link/activity.
Disable any yellow LEDs for now, later on we can add alarm indications
etc. to these.
When dropping the net package in 5031ff6, a rebuild + test was not made
before pusing to main. As a result Infix suddenly lost one of its most
important packages, iproute2.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Relocate Finit conf to package, like klish and confd. Add condition to
ensure it is not started before mdev/udevd are up and kernel LED modules
have been loaded properly.
Also, add tmpfiles.conf to ensure /run/led is recreated at every boot.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Only config no operational state yet.
routing
routing/control-plane-protocols
control-plane-protocol static name default
static-routes
ipv4 route 192.168.200.0/24 next-hop special-next-hop blackhole
The intention of this is to serve as a help/guidance for both devs and
reviewers of pull requests.
Baseline is taken from Linux v6.5.6, with some (possibly) controversial
additions (at the end of the file):
- Do not enforce max line length
- Alignment of variables, both when assigning and declaring
- Use spaces to adjust when leading tabs are not enough (as Emacs)
I've also added a couple of exceptions for macros like TAILQ_FOREACH()
which are used as control statments (if, while, for), so the opening
brace should be on the same line -- otherwise clang-format thinkts we
are creating a recursive function ...
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
This patch adds PID readiness notification to Net-SNMP. This is
required for synchronizing processes like subagents.
PID readiness is similar to systemd READY=1 notification, which
Finit supports, but Net-SNMP only supports that at first startup
not after SIGHUP.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
There should be no functional change in this patch.
In this patch we rewrite the data collection in python3. This is the
new script called "yanger". It runs various commands on the system,
such as "ip" and "ethtool". It then mangles the output data from these
commands into valid YANG data.
The yanger script is started from the sysrepo callback in the statd c
code. Its output is parsed using lyd_parse_data_fd().
This means that the daemon part of statd is still written in c and the
new python code is only used when getting a query callback from
sysrepo. The c code still handles the interface netlink messages from
the kernel which controls what interfaces statd should do sysrepo
subscribe/unsubscribe to.
Signed-off-by: Richard Alpe <richard@bit42.se>
Expose fsystemv() in header and remove static. This function can be
useful for others that needs to be in control of any output stream.
Signed-off-by: Richard Alpe <richard@bit42.se>
