- add default-deny-all rule from 2341e07
- enable iburst for the ntp client (quicker initial sync)
- bump meta version (to skip .cfg migration at boot)
Fix#750 [skip ci]
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
When the interface is up and has a 'proto dhcp' address the WAN LED is
lit up. When the interface goes down, or loses its DHCP lease, the LED
is turned off.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
This patch further cleans up the r2s kernel config and also enables the
input event framework for the gpio0 reset button on the device.
The very simple input-event-daemon is introduced, with the only purpose
of listening to /dev/input/event1 for KEY_RESTART and trigger reboot.
Some helpful tooling is also added to help debug events (evtest).
Issue #276
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
This serves as an example of how a board specific builds in Infix can
carry a static factory-config. This will be extended upon as we add
support for DHCP server, WiFi access point, and firewall support.
For now the following features are added:
- Default hostname: r2s instead of infix-00-00-00
- LAN port always at 192.168.2.1/24, IPv6 SLAAC enabled
- WAN port has DHCP enabled for IPv4, IPv6 SLAAC disabled
- NTP client enabled, default server pool.ntp.org
- DHCP client is set up to request and allow ntp server
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
The R2S has a minimal set of system LEDs, all of which are single color.
This commit tries to distill and map the essence of the Infix functions
to available LEDs.
The SYS LED is turned on (fainy red) at power-on, when U-Boot has loaded
the kernel it turns the SYS LED bright red on. The idea is then to turn
the red SYS LED off as soon as the system has successfully loaded system
startup-config, and then turn the green LAN LED on. Indicating that the
both the device is operational and that the user can connect to the LAN
port.
The WAN LED is given a "wan-up" input condition, with the intention of
turning it on (green) when the device has acquired a DHCP address.
The failure modes, which in many ways is the essence of Infix signaling,
are fail-safe and panic, triggered by loading failure-config, or failing
to loadd failure-config, respectively. In fail-safe mode the SYS LED is
blinking red at 5 Hz and in panic mode *all* LEDs blink at 5 Hz.
Issue #276
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Joachim Wiberg