There's a case where the first query is lost due to the network just
starting up. To handle this we introduce a retry loop in the test case
that waits for a second query message to be sent.
In this commit we also lower the query interval to speed up the case
when the first message is lost. Ideally mcd (the underlying multicast
daemon) should implement a Startup Query Interval to send it even
faster.
Signed-off-by: Richard Alpe <richard@bit42.se>
RESTCONF, or NETCONF, may not always be available. Break out and
refactor transport detection/reachability.
NOTE: The shared code paths between wait.py and util.py:wait_boot()
have been refactored as well to reduce code duplication.
Issue #597
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Instead of copy factoy config to reset between tests,
use the new test-config.cfg.
Change the logic in the factory config since the default values have changed.
Previous xpath may or may not been an xpath, we still called it xpath.
Remove the obscure function get_xpath() and instead transform to a
URI in restconf.py
This fix issue #490
Signed-off-by: Mattias Walström <lazzer@gmail.com>
All typedefs and identities should be declared in the module that uses
them unless other modules need them. This change also makes it easier
to work with tools like yanglint and pyang.
Signed-off-by: Joachim Wiberg <troglobit@gmail.com>
Use must{,_not}_receive instead of the general sniffer, so that we can
continue the test as soon as we see the transmission at the receiver,
rather than always waiting the full 5s.
While we're here:
- Show the port mappings in the top block-comment
- Define a few more steps to show the user what is going on
Use must{,_not}_receive instead of the general sniffer, so that we can
continue the test as soon as we see the transmission at the receiver,
rather than always waiting the full 5s.
While we're here:
- Show the port mappings in the top block-comment
- Define a few more steps to show the user what is going on
- Avoid global variable references in set_static_multicast_filter()
Rather than setting up and tearing down two identical namespaces,
create it once and use it for the duration of the test. (This is
probably a documentation issue with Infamy: there is no requirement
that test.steps are direct descendants of the test, but until this
point there was no example of this in the source base)
In the process of this, it was also discovered that no positive ping
test was done over v6, so that has been added.
